Charles Puffer wrote:
> Robert Seaman wrote:
>> You have to start slowly and gradualy increase speed of extractor.
>> very slow
>> for unwired frames
>>
>> <terpla122@[EMAIL PROTECTED]
> wrote in message
>> news:1189735760.064577.161090@[EMAIL PROTECTED]
>>> First off... thanks for all the responses about the best uncapping
>>> method.
>>>
>>> My next question is how many rpm's does the 22" drum of the radial
>>> extractor need to be spun to extract from unwired, wax foundation,
>>> shallow frames?
>>>
>>> The honey will be at about 80-85 degrees.
>>>
>>> Sure don't want to ruin any comb.
>>>
>>
>>
> Also if you have to flip the frames remember that side to is not getting
> extracted. So do not speed up to much on side one.
No, the poster stated that he is using a Radial extractor, so both sides
are done together, as far as speed goes, there are no hard and fast
rules, start slowly and see how it goes, if you break any combs then you
know to go slower next time but for longer, only experience with your
kit will tell you how fast and for how long you need to go.
Ben.
|
